NEW

GC201 Hammer Lubrication Controller

Developed By Northwest Automatic Lubrication and made in the USA.

The GC201 controller is the newest state of the art in-cab Hammer lubrication control system from Northwest Automatic Lubrication. 

It combines Hammer lubrication and auxiliary hydraulic system shutdown with monitoring and full system memory functions.  It is compatible with standard or proportional auxiliary hydraulic systems.

The control system will operate a Hammer lubrication pump and shut off the auxiliary hydraulics in the event of low lube lubricant level or system malfunction.

Controller will operate with voltages from 9-32 volts DC.

Operational Features:

Negative or Positive            Enable switch option.

Negative or Positive            Pressure switch option.

Negative or Positive            Low level options.

High Pressure Time:            5 – 120 seconds, (The amount of accumulated time to create a fault warning).

Low level Time:                   1 – 120 seconds, (The amount of accumulated time to create a fault warning).

Memory Features:

Total system on-time.

Total motor run-time.

Total high pressure fault time.

Total low level fault time.

Total pumping unit run-time (to determine when to replace pumping unit).

Total motor error time (short or open).

Additional Features:

• The GC201 in mode 20 and  21 will test and display the continuity of the inputs and outputs.
• In mode 22 the real time motor amp draw will be displayed.  Pump can be turned on or off  for testing purposes.
• The GC201 is pass code protected to prevent unauthorized altering of the system parameters.
• Soft start and soft stop on drive motor circuit to extend motor life.
• Dimensions:  5 ¼” high, 4 ¾” wide, 1 ¾” deep.  4” centers on mounting holes.

Call Northwest Automatic Lubrication, 1-888-267-7695, for additional information.